Jump to content

Problem with 2D forward view


Buzzer
 Share

Recommended Posts

As part of my therapy while hiding from this COVID-19 situation, I have been building a 2D cockpit for the Flight Replicas DC4. I have it almost finished but have a problem with the view forward from inside the aircraft in MAIN_PANEL view. When the aircraft loads, the view of the outside through the windscreen only covers about 40% from the top (452 pixels on a 1920x1080 monitor). I can drag the lower edge to the bottom of the screen and all is fine, until I swap to another screen and return to the main, whereby the view is once again reduced to 40%. All other screens are OK and show a full view of the outside (excluding that portion that is obstructed by the aircraft framing).

 

No other aircraft does this and they are all OK. I have checked the [VIEWS] and [Window00] sections and compared to other aircraft but cannot find any explanation. I have searched the internet for some clue but can only find information about setting up views etc.

 

If anyone can point me in the right direction I would really appreciate it.

Screen 1.JPG

Link to comment
Share on other sites

Thank you, I found the problem. I must have accidentally moved the vertical slider on FS Panel Studio. It was only occurring on one panel but took a while to locate the problem.FS Panel Studio screen shot.JPG
Link to comment
Share on other sites

 Share

×
×
  • Create New...